---

ask lang ko kung pwde ba ni na setup?


naa na naka set up na wireless network diri sa balay na gipuyan namo. ang problema lang, perting hinaya sa signal, duol lang kaayo mawala na ang signal.pailisan ko unta ni pero dili man gud ni akoa ba.. ang plano nako ani:

tauran nako ug another wireless router (B) ang ilahang current na wireless router (A) kay murag daut ata jud. bali ang ako router (B) mukuha ug internet connection sa router (A). naa pa man LAN port sa likod sa router (A)...

unta pwede ni. kay kapoy diri pakabit ug connection.. salamat.. reply lang..

pwde po yn, ang tawag jn ay cascading router. signal strength will depend on ur new router but the speed rate would be the same.

salamat..

sa router jud diri sa balay ang problema kay ang mga silingan na signal nko diri makuha pa man.. 3 levels ang signal. pero ang dri sa balay, pkas kwarto lang wala na while ang mga silingan na signal, kuha kaayo... kung pwede lang i hack.. hehe..


salamat kaayo

Ibridge nlang ang AP nimo bai para dili nako mag cable.

nalibog ko neil.. hehe

you mean i bridge wirelessly ang mga router?

kay plano nko mag palit nalang ug wireless router unya diri.. gaba perti bya jud mahala!!! heheh.. salamat

kung naa moy cheap solution para ani, mas labing maayo. tabang lang jud kay short nko sa budget.. thanks

mas maau pa wired na lng imong ikabit kaysa wireless.
mas paspas pa.
tapos less cost pa jud kay utp cable = P8 per mtr and 2 rj45 = P5 each.
sure pa nga paspas jud ang imong net dba.

@shibbee... if you are a techie you can do the cascading router set-up, here's a simple guide... got this on networksolutions4u website..


ROUTER TO ROUTER CASCADING A SIMPLE GUIDE...


NOTE: Before you connect a router to another, make sure that both have different IP addresses. This is mandatory because both routers may be set to the same IP address by default. If both routers have the same IP address, you need to change the IP address of the second router to prevent any conflict.

There are two ways to cascade a router to another router:

1. Connecting one of the Ethernet ports (LAN ports) of the second Router to one of the Ethernet ports (LAN ports) of the main router.

2. Connecting the Internet port (WAN port) of the second Router to one of the Ethernet ports (LAN ports) of the main router.

By connecting the second router’s Ethernet port to the main router’s Ethernet port, the computers connected to both routers will be on the same LAN IP segment. This will allow sharing of network resources within the network. By connecting the second router’s Internet port to the main router’s Ethernet port, it will be easier to identify which router the computers are connected to since they will have different LAN IP segments.

NOTE: Before configuring the second router, make sure that it is not connected to the main router, where the broadband modem is connected. Then follow these instructions:

Cascading the Router to Another Router (LAN-LAN)
__________________________________________

To cascade your router to another router, you need to perform two steps:

1. Connecting a Computer to the Router

2. Configuring the Router with LAN-to-LAN Connection

NOTE: The steps mentioned should be performed on the second router.

Connecting a Computer to the Router

1.Shutdown the computer and plug it to any of the numbered ports at the back of the router.

2. Plug the supplied power adapter in the router.

Configuring the Router with LAN-to-LAN Connection

1.Access the router’s web-based setup page

2.When the router’s web-based setup page appears, look for Local IP Address and change it to “192.168.1.2

3.When the web-based setup page opens, look for DHCP Server and click Disable

4.Click save settings

5.Click Advanced Routing and change Operating Mode to Router.

6.Click save settings

7.Connect a standard Ethernet network cable to one of the numbered Ethernet ports on the main router, where the broadband modem is connected. Then, connect the other end of the Ethernet cable to the Ethernet port of the router that you have just configured.

Cascading the Router to Another Router (Internet-LAN)

To cascade your router to another router, you need to perform two steps:

1. Connecting a Computer to the Router

2. Configuring the Router with Internet-to-LAN Connection

NOTE: The steps mentioned should be performed on the second router.

1.Shutdown the computer and plug it to any of the numbered ports at the back of the router.

2.Plug the supplied power adapter in the router. Configuring the Router with Internet-to-LAN Connection

1.Access the router’s web-based setup page

2.When the router’s web-based setup page appears, look for Local IP Address and change it to “192.168.2.1

3.Click save settings.

4. Connect a standard Ethernet network cable to one of the numbered Ethernet ports on the main router, where the broadband modem is connected. Then connect the other end of the Ethernet cable to the Internet port of the router that you have just configured.

pero... ingun man kaha ka na murag daut ang current wireless router, instead of cascading it... why not REPLACED the current wireless router entirely para makasiguro gyud ka na ok ang connection, wa pay possibility of IP conflicts sa imong duha ka wireless router...

just a thought though.... or matud pa ni totomicslan, kung gusto gyud ka ug paspas na connection, nothing beats a wired one...

oki bai.. salamat sa mga tubag ninyo. mahadlok ko magbuot buot ug kambyo diri ug butang man gud.

thanks!

Bro check daw ni.
http://uk.youtube.com/watch?v=LY8Wi7XRXCA
or
http://www.hawkingtech.com/products/pro ... ProdID=379

Bro try daw ni nga procedure basin diay mo effect dili naka maka gasto...

Punta ka sa Device manager (right click 'my computer' and click manage and then click on the device manager icon)
E open ang 'network adapters' branch (i presume ni sya nga mao ni ang imong wireless card) .
right click on your wireless card and click properties
click advanced
click power save mode
and select "disabled"
Bro check pud og update sa imong wireless network driver...adto ka sa elang website kong unsa man ng brand sa imong wireless card.

Basin diay makatabang ni tanan bro... so ang imong e palit og wireless router palit nalang nimo og San Mig Light lingaw pa mo sa imong mga barkada unya habang ga chat nag inum mo...hahaha...

Naa pa isa bro unsa man diay brand sa imong wireless router? kong linksys na or U.S. Robotic naa man na sila mga wireless extender mas barato pa kay sa mga router... Or wireless access point nalang para dili lisod mag configure ayaw na palit og wireless router...

Try pud daw og check ni nga software



Description ani mao ni.

Wireless Network Ignition 2.0 will manage the process of getting and staying connected to your wireless network.

You will be able to:
* Eliminate guesswork
* Instantly resolve technical problems
* Avoid the frustration of installing and configuring your wireless network
* Enjoy a simple, secure and private wireless network access at home or on the road

Key features:
* Simple Wireless Network Setup & Configuration
* Automatically detects all wireless network parameters
* Seamless wireless PC/network configuration
* Step-by-step set-up procedures make wireless connectivity seamless
* Dynamically determines all wireless access points (WAP)
* Provides information and instant connection to specific WAPs
* Powerful, Personal Security
* Encryption wizard easily configures PC
* Auto-generation and management of encryption keys
* Supports popular encryption standards (32-bit, 64-bit, etc.)
* Self-diagnosis and Self-healing
* Sophisticated network debugging engine
* Networ k failure and auto repair features to resolve problems
* The Wireless Network, to Go
* Instant, safe, and secure connection to wireless networks outside of home environment
* Creates wireless network history and establishes customizable wireless profiles

Benefits
* Trouble-free wireless network setup and operation
* Safe and secure wireless access
* Eliminate frustrating customer support calls
* Instantly resolve technical issues yourself

kung ok sa silingan tapos sa imoha dli posible nga dead spot imung area(daghan factors ngano ing-ana). kung gusto ka makamura ug walay cables pwede palit nlng kag access point buhaton nmu sya ug repeater sa main wireless router. kana lang kung pwede kung compatible imung AP ug imung ROUTER.. sa linksys kalimot ko sa model pwede na..

daghang salamat hehe..

excuse, na try na nko ang 1st vid wala may epekto.hehe...


nka isip ko pakabit na lang ko ug ako na linya oi...


pwede ba na ang laptop na wifi + bluetooth na naay mobile usb broadband internet (murag pareha sa smartbro na maski asa nimo madala) gamiton nimo sya as internet source para maka gamit pud ang isa ka laptop na wifi/bluetooth ready?

Pwede kaau basta imong mobile unit naay naay modem or pwede ka mag browse og internet. Kaso hinay lang jud sya din mahal pud depende sa rate sa provider nimo.

Mas maau kong pakabit nalang ka sarili nimo nga line para solo jud nimo.

Pero kong gusto ka mobility bisan asa ka dapit magamit nimo nga dili ka mag worry basin ma putol...kini gamita
Naa lang jud kamahalan





Pero bisan naa ka sa isa ka island ana walay signal sa cellphone naa jud kay internet maka DS paka anytime mag abang ka sa mga new nga baligya.

nah nayabag na

dakoa sad anang satellite dish oi. hehe


tama jud. nayabag nah. hehe


<b>w8, asa pwd mka.buy ug barato na router?</b>
kanang router na pwd wired ug wireless.

<b>tapos what brand ang nindut na router?</b>

pang.gm8 lng gd s blay kay kami tanan naa laptop. tnx.